Filter
Top Products
English
|
63
Cancelling Category and Channel Search mode
Press the [MENU] button for at least 1 second,
and then press it again briefly.
⁄
• You cannot Channel search until the category
information is acquired.
Preset Memory
Putting the channel in the memory.
1
Select the channel you wish to store in the
preset memory
2
Enter Menu List mode
Press the [MENU] button.
3
Enter Preset Memory mode
Turn the [Volume] knob and press it when the
desired item is displayed.
Select “List & Memory”.
4
Select the number to put in the memory
Turn the [Volume] knob and press it for at least
2 seconds when the desired item is displayed.
Select the preset number.
⁄
• Only the channel number is stored. Category information
is not stored.
• Up to six channels can be registered for each preset
band. Selecting “Mixed” for “Tuner Preset Type” allows
you to register up to six stations including FM, AM, and
another Satellite Radio Tuner regardless of the selected
source. See “Tuner Preset Type” of <Initial Settings> (page
43).
Preset Tuning
Recalling the channels in the memory.
1
Select Satellite Radio source
2
Enter Menu List mode
Press the [MENU] button.
3
Select a desired station in the memory
Turn the [Volume] knob and press it when the
desired item is displayed.
Select “List & Memory” > Preset number.
Channel Scan
Every receivable Channel is checked for 10 seconds.
1
Select Satellite Radio source
2
Enter Menu List mode
Press the [MENU] button.
3
Start Channel Scan
Turn the [Volume] knob and press it when the
desired item is displayed.
Select “Channel Scan”.
4
Release it when the channel you want to listen
to is received
Press the [Volume] knob.
Function of remote control
Direct Access Tuning
Entering the channel and tuning.
1
Select Satellite Radio source
2
Enter Direct Access Tuning mode
Press the [DIRECT] button on the remote
control.
3
Enter the channel
Press the number buttons.
4
Tune in to the entered channel
Press the [4] or [¢] button.
Cancelling Direct Access Tuning
Press the [DIRECT] button on the remote
control.
⁄
• If you make no button operation for 10 seconds, the
Direct Access Tuning mode is automatically canceled.
• If you cannot receive any signal in the input Channel due
to bad conditions on radio wave or other such problems,
“Acquiring Signal”/ “No Signal” appears.