Filter
Top Products
84
|
KIV-BT901/ KIV-701
Troubleshooting Guide
The messages shown below display your
systems condition.
TOC Error: • No disc has been loaded in the disc
magazine.
• The CD is quite dirty. The CD is upside-
down. The CD is scratched a lot.
Error 05: The disc is unreadable.
Error 77: The unit is malfunctioning for some reason.
Press the reset button on the unit. If the
“Error 77” code does not disappear, consult
your nearest service center.
Error 99: Something is wrong with the disc magazine.
Or the unit is malfunctioning for some reason.
Check the disc magazine. And then press
the reset button on the unit. If the “Error
99” code does not disappear, consult your
nearest service center.
Protect (Blink): The speaker wire has a short-circuit or
touches the chassis of the vehicle, and then
the protection function is activated.
Wire or insulate the speaker cable properly
and press the reset button. If the “Protect”
code does not disappear, consult your
nearest service center.
Unsupported File:
An Audio file is played with a format that this
unit can’t support.
Copy Protection:
A copy-protected file is played.
Read Error: The file system of the connected USB device
is broken.
Copy the files and folders for the USB
device again. If the error message is still
displayed, initialize the USB device or use
other USB devices.
No Device: The USB device is selected as a source
although no USB device is connected.
Change the source to any source other
than USB. Connect an USB device, and
change the source to USB again.
N/A Device: • An unsupported USB device is connected.
• Connection to the iPod has failed.
Check that the connected iPod is an iPod
that is supported. See <iPod/iPhone that
can be connected to this unit> (page 70) for
information on supported iPods.
No Media File/Error 15:
• The connected USB device contains no
playable audio file.
• Media was played that does not have data
recorded that the unit can play.
USB ERROR: Some trouble may have occurred to the
connected USB device.
Remove the USB device, then cycle the
power switch to ON. If the same display is
repeated, use another USB device.
iPod Error: Connection to the iPod has failed.
Remove the USB device and then
reconnect it.
Reset the iPod.
USB REMOVE (Blink):
The Remove mode has been selected for the
USB device/iPod. You can remove the USB
device/iPod safely.
Over Capacity: Recording or copying was canceled because
internal memory space ran out while copying
from USB device.
Delete unnecessary files and record or
copy once more.
Copy Error: • An incompatible digital audio player was
used.
• Cannot copy because the USB device is not
firmly inserted.
Delete Error:
Format Error: Abnormal condition detected while deleting
or formatting.
Repeat the operation once more. This may
take some time. If the message recurs,
contact your nearest Kenwood dealer.
Can’t Download:
Download Error:
This unit does not work properly for some
reason.
Press the reset button to download it
again. If this error is still displayed, consult
a local Kenwood dealer.
Try all over again from the start. If this error
is still displayed, consult a local Kenwood
dealer.
Writing Error: Writing failed while the file was downloaded.
Try the downloading again.
Tuner/ SIRIUS/ XM/ HD Radio reception
Memory Full: The TAG Memory of HD Radio receiver or
Radio Data System is full.
iPod Full: The iPod Memory is full.
No TAG Function:
iPod which does not support the TAG
Memory is connected.
N/A Channels: No receivable channel and category.
No Access: The procedure preset with mixed preset
memory function cannot be available.
The preset content may not be recalled
depending on the selected band or source.