Filter
Top Products
English
|
83
What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
General
? The Touch Sensor Tone does not sound.
The preout jack is being used.
The Touch Sensor Tone cannot be output from
the preout jack.
? The illumination flashes when the knob or button
is operated.
This is the key illumination effect.
You set this effect in “ILLUMI Effect” of <Display
Setting> (page 38).
? The key illumination effect brought about in
conjunction with the sound volume is small.
The key illumination effect may be insufficient
depending on the sound volume and sound quality.
? No image is output from the AV Output terminal of
iPod.
“AV Out Set” is not set properly.
The “AV Out Set” of <Initial Settings> (page 43) is
set ON.
The Internal Memory source or Pandora source is
selected.
Since the Internal Memory source or Pandora
source cannot be used together with the iPod
source, the output from the AV Output terminal
stops.
Tuner source
? Radio reception is poor.
The car antenna is not extended.
Pull the antenna out all the way.
Audio file source
? The sound skips when an Audio file is being
played.
The recording condition is bad.
Record the media again or use another media.
Hands-free
? The hands-free talk volume is low.
The hands-free talk volume is set at a low level.
The hands-free talk volume can be adjusted
independently. Adjust it during hands-free talk.
“Mic Gain”, “Noise Reduction” and “Echo Cancel
Level” of <Bluetooth Setting> (page 54).
? No sound is heard from the rear speakers.
You are talking in the hand-free talk mode.
No sound is heard from the rear speakers in the
hands-free talk mode.
? No beep is heard at reception of an incoming call.
No beep is heard depending on the type of your
cell-phone.
The “Call Beep” of <Bluetooth Setting> (page 54) is
set ON.
? Voice is not recognized.
The vehicle window is open.
If the surrounding noise is large, voice cannot be
recognized properly. Close the vehicle windows
to reduce noise.
Small voice.
If voice is too small, it cannot be recognized
properly. Speak into the microphone a little more
loudly and naturally.
The person uttering the voice tag is not the one who
registered the it.
Only the voice of the person who registered the
voice tag can be recognized.
Bluetooth audio source
? The Bluetooth audio player cannot be registered
(pairing).
The PIN code is fixed.
When a PIN code is specified in the Instruction
Manual for Bluetooth Audio Player, register it
with reference to <Registering PIN Code> (page
57) to register the Bluetooth audio player. If no PIN
code is specified in the Instruction Manual, try
“0000”.
? The sound from the Bluetooth audio player is
discontinuous.
The distance between this unit and audio player is
too far.
Move the audio player nearer to this unit.
Another Bluetooth device is affecting the Bluetooth
communication.
Turn off another Bluetooth device.
Move another Bluetooth device away from this
unit.
Another Bluetooth device or profile is used for
communication.
The downloading of the Phone book or the SMS
disconnects the sound.