Filter
Top Products
Commands Chapter 5
EuroPak-15a Receiver User Manual Rev 5 69
5.3.19 UNLOGALL Remove All Logs from Logging Control
This command disables all logs on the specified port only. All other ports are unaffected.
This command does not disable logs that have the HOLD attribute set. (See the LOG command in Section
5.3.10 on Page 59 for more information on this attribute). To disable logs with the HOLD attribute, use the
UNLOG command.
Syntax: Message ID: 38
Example:
UNLOGALL
UNLOGALL [ PORT ]
Field
Field
Name
Valid Values Description Format
Binary
Bytes
Binary
Offset
1 header
This field contains the Abbreviated ASCII command name. See Section 4.1 on
Page 31.
H 0
2 port See Table 10 on Page 39.
Serial port at which logging is to
disabled. If a value is not provided,
COM1 is assumed.
Enum 4 H
3 Reserved (always 0). Enum 4 H+4