Filter
Top Products
Before use
6
What’s in the box
RCA audio cable × 1
RI cable × 1
Remote control (RC-887C) x 1
Batteries for remote control (AAA) × 2
Using the remote control
Remove the cover from the back of the remote control
and insert two AAA batteries with their +/- ends oriented
in the case as shown. Replace the cover.
If the operation range of the remote control decreases,
the batteries have become exhausted. In this case,
replace the batteries with new ones. Dispose of the
used batteries according to the instructions on them or
requirements set by your local municipality.
Remote Control
Sensor
Approx
16ft (5m)
When using the remote control, point it toward the
remote control signal receiver on the main unit from a
distance of 5 m (16 ft) or less.
Do not place obstructions between the main unit and
the remote control.
The remote control might not work if the remote
control signal receiver on the unit is exposed to direct
sunlight or bright light. If this occurs, try moving the
unit.
Beware that use of this remote control could cause
the unintentional operation of other devices that can
be controlled by infrared rays.
Precautions for use
Do not install this unit in a location that could become
hot. This includes places that are exposed to direct
sunlight or near a radiator, heater, stove or other
heating equipment. Moreover, do not place it on top of
an amplifier or other equipment that generates heat.
Doing so could cause discoloration or deformation.
Avoid locations that are extremely cold or exposed to
excessive humidity or dust.
In order to enable good heat dissipation, leave at
least 20 cm (8") between this unit and walls and other
equipment when installing it. If you put it in a rack,
take precautions to prevent overheating by leaving at
least 5 cm (2“) open above the top of the unit and at
least 10 cm (4“) open behind the unit.
Do not put cloth on top of the unit or place the unit on
top of bedding or thick carpet. Doing so could cause
the unit to overheat or damage it.
Do not lift or move the unit during playback because
the disc rotates at high speed. Doing so could
damage the disc.
Always remove any loaded disc before moving this
unit or packing it for installation in a different location,
for example. Moving the unit with a disc inside could
cause a malfunction.
This unit consumes power when in standby mode.
Supply voltage to the unit that matches the voltage
indicated on the rear panel. If you are in any doubt
regarding this matter, consult an electrician.
Do not open the body of the unit as this might result
in damage to the circuitry or cause electric shock. If
a foreign object should get into the unit, contact your
dealer.
When removing the power plug from an outlet, always
pull directly on the plug. Never pull on the cord itself.
If a TV is turned on while the unit is on, static
might appear on the TV screen depending on the
characteristics of the TV broadcast signal. This is not
a malfunction of the unit nor of the TV. If this occurs,
turn the unit off.
Maintenance
Wipe dirt from the top cover and other panel surfaces
using a soft cloth that has been slightly dampened with a
diluted neutral cleanser.
Do not use chemically-treated wipes, thinner or similar
substances because they could damage the surface of
the unit.
For safety, disconnect the power cord from the
socket before cleaning.