Filter
Top Products
104
Advanced Setup—Continued
You can assign a default listening mode to each input source that will be selected automatically when you select each
input source. For example, you can set the default listening mode to be used with Dolby Digital input signals. You can
select other listening modes during playback, but the mode specified here will be resumed once the AV receiver has been
set to Standby.
Notes:
• If you connect an input component (such as UP-A1
Dock that seated iPod) to the UNIVERSAL PORT
jack, you can assign only “Analog” to PORT input
source.
• This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.
Assigning Listening Modes to Input Sources
1
Press the [RECEIVER] button followed by
the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make sure the
appropriate external input is selected on your TV.
2
Use the Up and Down [ ]/[ ] buttons to
select “5. Listening Mode Preset”, and
then press [ENTER].
The “Listening Mode Preset” menu appears.
3
Use the Up and Down [ ]/[ ] buttons to
select the input source that you want to
set, and then press [ENTER].
The signal format selection menu appears.
For TUNER input source only “Analog” will be
available. For NET input source only “Digital”
will be available.
Analog/PCM
Dolby Digital
DTS
D.F. 2ch
D.F. Mono
Last Valid
Last Valid
Last Valid
Last Valid
Last Valid
5–1. Listening Mode Preset
DVD/BD
4
Use the Up and Down [ ]/[ ] buttons to
select the signal format that you want to
set, and then use the Left and Right [ ]/
[ ] buttons to select a listening mode.
5
When you’ve finished, press the [SETUP]
button.
The setup menu closes.
Listening Mode Preset
Analog/PCM: With this setting, you can specify the listening mode to be used when an analog (CD, TV, LD,
VHS, MD, turntable, radio, cassette, cable, satellite, etc.) or PCM digital (CD, DVD, etc.) audio signal is
played.
Dolby Digital: With this setting, you can specify the listening mode to be used when a Dolby Digital or Dolby
Digital Plus format digital audio signal is played (DVD, etc.).
DTS: With this setting, you can specify the listening mode to be used when a DTS or DTS-HD High Resolution
format digital audio signal is played (DVD, LD, CD, etc.).
D.F. 2ch: Specifies the default listening mode for 2-channel (2/0) stereo sources in a digital format, such as
Dolby Digital or DTS.
D.F. Mono: With this setting, you can specify the listening mode to be used when a mono digital audio signal
is played (DVD, etc.).
Multich PCM: Specifies the default listening mode for multichannel PCM sources input via a HDMI IN, such
as DVD-Audio.
Dolby TrueHD: Specifies the default listening mode for Dolby TrueHD sources, such as Blu-ray or HD DVD
(input via HDMI).
DTS-HD Master Audio: Specifies the default listening mode for DTS-HD Master Audio sources, such as Blu-
ray or HD DVD (input via HDMI).
DSD: Specifies the default listening mode for DSD multichannel sources, such as Super Audio CD.
Only listening modes that can be used with each input signal format can be selected (see pages 77 to 83).
The Last Valid option means that the listening mode selected last will be used.