Filter
Top Products
53
First Time Setup—Continued
If the impedance of any speaker is 4 ohms or more but
less than 6, set the minimum speaker impedance to 4
ohms.
If you’ve connected your front speakers to the FRONT
L/R and SURR BACK/ZONE 3 L/R terminal posts for
bi-amping, you must change the “Speakers Type(Front)”
setting. For hookup information, see “Bi-amping the
Front Speakers” on page 21.
Notes:
• When bi-amping is used, the AV receiver is able to
drive up to 7.2 speakers in the main room.
• Before you change these settings, turn down the
volume.
Powered Zone 2/3
See “Setting the Powered Zone 2/3” on page 127.
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
Speaker Settings
1
Press the [RECEIVER] button,
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [ ]/[ ] but-
tons to select “2. Speaker
Setup”, and then press [ENTER].
The “Speaker Setup” menu appears.
3
Use the Up and Down [ ]/[ ] but-
tons to select “1. Speaker Set-
tings”, and then press [ENTER].
The “Speaker Settings” menu appears.
If you change these settings, you must run
Audyssey MultEQ
®
XT Room Correction and
Speaker Setup again (see page 56).
2. Speaker Setup
1. Speaker Settings
2. Speaker Configuration
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
2–1. Speaker Settings
Speaker Impedance
Speakers Type(Front)
Powered Zone2
Powered Zone3
6ohms
Normal
Not Act
Not Act
4
Use the Up and Down [ ]/[ ] but-
tons to select “Speaker Imped-
ance”, and then use the Left and
Right [ ]/[ ] buttons to select:
4ohms: Select if the impedance of any
speaker is 4 ohms or more but
less than 6.
6ohms: Select if the impedances of all
speakers are between 6 and
16 ohms.
5
Use the Up and Down [ ]/[ ] but-
tons to select “Speakers
Type(Front)”, and then use the
Left and Right [ ]/[ ] buttons to
select:
Normal: Select this if you’ve con-
nected your front speakers
normally.
Bi-Amp: Select this if you’ve con-
nected your front speakers
for bi-amped operation.
Note:
Surround back speakers and Powered
Zone3 cannot be used if “Speakers
Type(Front)” is set to “Bi-Amp”.
6
Press the [SETUP] button.
The setup menu closes.