Filter
Top Products
43
Turning On the AV receiver
European and Asian models: To completely shut down the AV receiver, set the [POWER] switch to the OFF position
().
ON/STANDBY ON/STANDBY
POWER
STANDBY
ON
RECEIVER
STANDBY indicator
(North American models)
(European and Asian models)
STANDBY indicator
Turning On and Standby
1
(European and Asian models)
Set the [POWER] switch to the ON position ( ).
The AV receiver enters Standby mode, and the STANDBY indicator comes on.
2
On the AV receiver, press the [ON/STANDBY] button.
On the remote controller, press the [RECEIVER] button, followed by the
[ON] button.
The AV receiver comes on, the display lights up, and the STANDBY indicator goes off.
Pressing the remote controller’s [ON] button again will turn on any components
connected via .
To turn the AV receiver off, press the [ON/STANDBY] button, or press the remote
controller’s [STANDBY] button. The AV receiver will enter Standby mode. To prevent
any loud surprises when you turn on the AV receiver, always turn down the volume
before you turn it off.
or
Remote
controller
AV receiver
Smooth Operation in a Few Easy Steps
To ensure smooth operation, here’s a few easy steps to help you configure the AV receiver before you use it for the
very first time. These settings only need to be made once.
■ Did you connect your TV to an HDMI output or COMPONENT VIDEO MONITOR OUT?
If you did, “Monitor Setup” on page 44.
■ Run MultEQ XT Room Correction and Speaker Setup—this is essential!
See “Audyssey MultEQ
®
XT Room Correction and Speaker Setup” on page 56.
■ Have you connected a component to an HDMI input,
component video input, or digital audio input?
If you have, see “HDMI Input Setup” on page 49, “Component Video
Input Setup” on page 50, or “Digital Audio Input Setup” on page 51
respectively.
■ Have you connected an Onkyo MD recorder, CD recorder,
or RI Dock?
If you have, see “Changing the Input Display” on page 55.
HDMI
OUT IN
TV/TAPE
MD recorder, CD recorder,
RI Dock