Filter
Top Products
109
Advanced Setup—Continued
HDMI Control (RIHD) On: enabled.
Off: disabled (default).
This function allows -compatible components connected via HDMI to be controlled with the AV
receiver.
Notes:
• , which stands for Remote Interactive over HDMI, is the name of the system control function found
on Onkyo components. The AV receiver can be used with CEC (Consumer Electronics Control), which
allows system control over HDMI and is part of the HDMI standard. CEC provides interoperability between
various components, however, operation with components other than -compatible components can-
not be guaranteed.
When set to “On” and close the menu, the name of connected -compatible components and
“RIHD On” are displayed on the AV receiver.
“Search…”
→ “(name)” → “RIHD On”
When the AV receiver cannot receive the name of the component, it is displayed as “Player*” or
“Recorder*”, etc (“*” means the number of two or more component).
When set to “Off” and close the menu, “RIHD Off” are displayed on the AV receiver.
“Disconnect” → “RIHD Off”
• Set it to “Off” when a connected piece of equipment is not compatible or it is unclear whether the equipment
is compatible or not.
• Set it to “Off” if the operation is not successful.
• Refer to the connected component’s instruction manual for details.
• The control does not support HDMI OUT SUB. Use HDMI OUT MAIN instead.
Power Control On: Power Control enabled.
Off: Power Control disabled.
To link the power functions of -compatible components connected via HDMI, select “On”.
This setting is set to “On” automatically when the above “HDMI Control (RIHD)” is set to “On” for the first
time.
Notes:
• The
“Power Control” setting can be set only when the above “HDMI Control (RIHD)” setting is set to “On”.
• HDMI power control only works with -compatible components that support it and may not work
properly with some components due to their settings or compatibility.
• When set to “On”, the power consumption on standby mode increases.
• When set to “On”, regardless of whether the AV receiver is On or on Standby, both audio and video received
by an HDMI input will be output from the HDMI output for playback on the TV or other component that’s
connected to the HDMI output.
• Refer to the connected component’s instruction manual for details.
TV Control On: TV Control enabled.
Off: TV Control disabled.
Set to “On” when you want to control the AV receiver from an -compatible TV that is connected to
HDMI.
Notes:
• Do not assign the component connected with the HDMI input to the TV/TAPE selector when you set “TV
Control” setting to “On”. Otherwise, appropriate CEC (Consumer Electronics Control) operation is not guar-
anteed.
•Set to
“Off” when the TV is not compatible or when it is unclear whether the TV is compatible or not.
• The “TV Control” setting can be set only when the above “HDMI Control (RIHD)” and “Power Control”
settings are both set to “On”.
• Refer to the connected component’s instruction manual for details.
Note:
After changing the settings of the
“HDMI Control (RIHD)”, “Power Control”, or “TV Control”, set all connected
pieces of equipment to Standby and then turn them on again. Refer to the User’s Manuals for all connected
pieces of equipment.