Filter
Top Products
93
Advanced Setup—Continued
Equalizer Settings
This setting is set automatically by Audyssey MultEQ
®
XT Room Correction and Speaker Setup (see page 56).
With the Equalizer settings, you can adjust the tone of speakers individually with a 7-band equalizer. The volume of
each speaker can be set on this page.
Notes:
• You can select: “63Hz”, “160Hz”, “400Hz”, “1000Hz”, “2500Hz”, “6300Hz”, or “16000Hz”. And for the sub-
woofer, “25Hz”, “40Hz”, “63Hz”, “100Hz”, or “160Hz”.
• While the Direct or Pure Audio listening mode is selected, the equalizer settings have no effect.
Equalizer Manual: You can adjust the equalizer for each speaker manually. If you selected “Manual”,
continue with this procedure.
1
Press the Down [ ] button to select “Channel”, and then use the
Left and Right [ ]/[ ] buttons to select a speaker.
2
Use the Up and Down [ ]/[ ] buttons to select a frequency, and
then use the Left and Right [ ]/[ ] buttons to adjust the level at
that frequency.
The volume at each frequency can be adjusted from –6 to +6 dB in 1 dB
steps.
Tip:
Low frequencies (e.g., 63Hz) affect bass sounds; high frequencies (e.g.,
16000Hz) affect treble sounds.
3
Use the Up [ ] button to select “Channel”, and then use the Left
and Right [ ]/[ ] buttons to select another speaker.
Repeat steps 1 and 2 for each speaker.
You cannot select speakers that you set to “No” or “None” in the “Speaker
Configuration” (page 90).
Audyssey: The tone for each speaker is set automatically by Audyssey MultEQ
®
XT Room
Correction and Speaker Setup. Be sure to select this setting after having performed
Room Correction and Speaker Setup. “Audyssey” is automatically selected when
“Dynamic EQ” and “Dynamic Volume” are set to “On” (see page 97).
Off: Tone off, response flat (default).