Filter
Top Products
108
Advanced Setup—Continued
HDMI
Audio TV Out Off: HDMI audio is not output to TV (default).
On: HDMI audio is output to TV and the sound will be heard from the TV
speakers.
This preference determines whether audio received at the HDMI input is output from the HDMI outputs. You
may want to turn this preference on if your TV is connected to the HDMI output and you want to listen to the
audio from a component that’s connected to an HDMI input, through your TV’s speakers. Normally, this should
be set to “Off”.
Notes:
• If
“On” is selected and the signal can be output by the TV, the AV receiver will output no sound through its
speakers.
• If “On” is selected, “TV Speaker On” appears on the Display by pressing the [DISPLAY] button.
• When “TV Control” is set to “On”, this setting is fixed at “Auto”.
• With some TVs and input signals, no sound may be output even when this setting is set to
“On”. When you
try to get audio from your TV, signals from the source component may be converted to the format supported
by your TV.
• When the “Audio TV Out” setting is set to
“On” or “TV Control” is set to “On” to hear from speakers of
-compatible TV (see page 26), by controlling the AV receiver’s volume, the AV receiver’s speakers
will produce sound while the TV’s speakers are muted. If your TV is not compatible with , the
volume level will not change. To stop the AV receiver’s speakers producing sound, change the settings,
change your TV’s settings, or turn down the AV receiver’s volume.
• When the “Audio TV Out” setting is set to “On”, the remote controller’s [AUDIO] button is disabled.
• If the “Monitor Out” setting is set to “Both (Main)” or “Both (Sub)” (page 47) and if your TV connected to
a priority output cannot output the audio, the sound will be heard from AV receiver’s speakers.
Lip Sync Disable: HDMI Lip Sync disabled (default).
Enable: HDMI Lip Sync enabled.
The AV receiver can be set to automatically correct any delay between the video and the audio, based on the
data from the connected monitor.
Notes:
• This function works only if your HDMI-compatible TV supports HDMI Lip Sync.
• You can check the amount of delay being applied by the HDMI Lip Sync function on the A/V Sync screen
(see page 99).
• If the “Monitor Out” setting is set to “HDMI Main”, “Both (Main)” or “Both” (page 47), the delay will be
corrected in accordance with the monitor connected to HDMI OUT MAIN. On the other hand, if “HDMI
Sub” or “Both (Sub)” is selected, the delay will be corrected in accordance with the monitor connected to
HDMI OUT SUB.
x.v.Color Disable: “x.v.Color” disabled (default).
Enable: “x.v.Color” enabled.
If your HDMI source and HDMI-compatible TV both support the “x.v.Color”, you can enable “x.v.Color” on
the AV receiver with this setting.
Notes:
• If the color is unnatural when “x.v.Color” is set to “Enable”, change the setting to
“Disable”.
• Refer to the connected component’s instruction manual for details.
• If the “Monitor Out” setting is set to “Both (Main)” or “Both (Sub)” (page 47) and if your TV connected to
a priority output does not support x.v.Color, output will be without x.v.Color control.