Filter
Top Products
39
Use one-touch play
1 After you switch on EasyLink, press play
on your device.
» The TV automatically switches to the
correct source.
Use one-touch play control
If you connect multiple HDMI-CEC devices
that support this setting, all such devices
respond to the play control buttons on this
TV remote control.
Caution
This is an advanced setting. Devices that do
not support this setting will not respond to the
TV remote control.
1 Press .
2 Select [Setup] > [TV settings] >
[EasyLink] > [EasyLink remote control].
3 Select [On] or [Off], then press OK.
Use one-touch standby
When you press on the TV remote control,
the TV and all HDMI-CEC compliant devices
switch to standby mode.
1 Press (Standby-On) on the TV’s or
device’s remote control.
» The TV and all connected HDMI
devices switch to standby.
Use Philips EasyLink
Get the most out of your HDMI-Consumer
Electronic Control (CEC) compliant devices
with Philips EasyLink enhanced control
features. If your HDMI-CEC compliant devices
are connected through HDMI, you can control
them at the same time with your TV remote
control.
To enable Philips EasyLink, you need to:
Connect at least two HDMI-CEC
compliant devices through HDMI
device properly
Switch on EasyLink
Note
The EasyLink-compliant device must be
switched on and selected as the source.
Philips does not guarantee 100%
interoperability with all HDMI CEC devices.
Switch on or off EasyLink
When you play an HDMI-CEC compliant
device, the TV switches on from standby, and
switches to the correct source.
Note
If you do not intend to use Philips EasyLink,
switch it off.
1 Press .
2 Select [Setup] > [TV settings] >
[EasyLink] > [EasyLink].
3 Select [On] or [Off], then press OK.
English
EN
Downloaded From TV-Manual.com Manuals