Filter
Top Products
4 Touch any of 18 to select the desired
level.
The parental lock level is set.
! LEVEL 8 Playback of the entire disc is pos-
sible (initial setting)
! LEVEL 7LEVEL 2 Playback of discs for
children and non-adult oriented discsis
possible
! LEVEL 1 Playbackof discs for children
only is possible
Notes
! We recommend to keepa record of yourcode
number in case you forget it.
! The parental lock level is recorded onthe disc.
You can confirm it by looking at the disc pack-
age, included literature or on thedisc itself.
With discs that do not featurea recorded par-
ental lock level, you cannot use parentallock.
! With some discs, parental lockoperates to
skip certain scenes only, after whichnormal
playback resumes. For details, refer to the
discs instructions.
Changing the level
You can change the set parental lock level.
1 Touch SETUP and VISUAL and then
touch PARENTAL.
2 Touch 09 to input the registered code
number.
3 Touch ENTER.
This enters the code number, and you can now
change the level.
# If you input an incorrect code number, the
icon
is displayed. Touch Cand input the cor-
rect code number.
# If you forget your code number, refer to If you
forget your code number on this page.
4 Touch any of 18 to select the desired
level.
The new parental lock level is set.
If you forget your code number
Refer to Changing the level on this page, and
touch C 10 times. The registered code number
is canceled, letting you register a new one.
Setting remote control
code type
When the remote control operation switch is
set to DVD, changing the remote control code
type enables you to operate the Pioneer DVD
player by the supplied remote control. There
are three remote codes, code type A, code
type B and code type AVH. When using this
unit with a multi-DVD player (e.g. XDV-P9), se-
lect code A. When using this unit only, select
code AVH.
! With this unit, code B cannot be used.
1 Set the remote control selection switch
on the left side of the remote control to
the appropriate position with a pen tip or
other pointed instrument .
! If you select AVH mode, there isno need to
take the following procedure.
! If you select A/B mode, takethe following
procedure and change the code typeto the
appropriate type.
2 Press 7 and 0 on the remote control si-
multaneously to change the code type.
Initially, the code type is set to A. Each time
you press 7 and 0 simultaneously on the re-
mote control the code type switches between
A and B.
Setting up the DVD player
En
73
Section
15
Setting up the DVD player