Filter
Top Products
Switching the warning tone
If the front panel is not detached from the
head unit within five seconds of turning off the
ignition, a warning tone will sound. You can
turn off the warning tone.
1 Touch A.MENU and INITIAL and then
touch DT. WARNING.
2 Touch a to turn warning tone on.
# To turn warning tone off, touch b.
Switching the auxiliary setting
It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1 Touch A.MENU and INITIAL and then
touch AUX.
2 Touch a to turn auxiliary setting on.
# To turn auxiliary setting off, touch b.
Setting the rear output and
subwoofer controller
This units rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (REAR SP FULL) or subwoofer
(REAR SP SUB. W) connection. If you switch
the rear output setting to the
REAR SP SUB. W, you can connect a rear
speaker lead directly to a subwoofer without
using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (REAR SP FULL). When rear out-
put are connected to full range speakers
(when REAR SP FULL is selected), you can
connect the RCA subwoofer output to a sub-
woofer. In this case, you can select whether to
use the subwoofer controllers (low pass filter,
phase) built-in PREOUT SUB.W or the auxili-
ary PREOUT FULL.
! When the multi-channel processor (e.g.,
DEQ-P7050) is connected to this unit, you
cannot operate this function.
1 Touch A.MENU and INITIAL and then
touch REAR SP.
2 Touch a or b to switch the rear output
setting.
Touch a to select full-range speaker and
REAR SP FULL appears in the display. Touch b
to select subwoofer and REAR SP SUB. W ap-
pears in the display.
# When no subwoofer is connected tothe rear
output, select REAR SP FULL.
# When a subwoofer is connected to therear
output, set for subwoofer REAR SP SUB.W.
# When the rear output setting is
REAR SP SUB. W, you cannot change the sub-
woofer controller.
3 Touch c or d to switch the subwoofer
output or non fading output.
Touch c to select subwoofer output and
PREOUT SUB.W appears in the display. Touch
d to select non fading output and
PREOUT FULL appears in the display.
Notes
! Even if you change this setting, there is no
output unless you turn the non fadingoutput
(refer to Using non fading output on page59)
or subwoofer output (refer to Usingsubwoofer
output on page 59) in the audio menuon.
! If you change the subwoofer controller, sub-
woofer output and non fading outputin the
audio menu return to the factory settings.
Initial Settings
En
75
Section
16
Initial Settings