Filter
Top Products
After installing the unit
30
ENGLISH ESPAÑOL DEUTSCH FRANÇAIS
ITALIANO NEDERLANDS
ENG/MASTER 96
31
1. Reconnecting the battery.
First, double-check that all connections are correct and that the unit is installed correctly.
Reassemble all vehicle components that you previously removed. Then reconnect the neg-
ative (–) cable to the negative (–) terminal of the battery.
2. Start the engine.
3. Press the reset button on the main unit.
Press the reset button on the main unit using a pointed object such as the point of a pen.
4. Enter the following settings:
• Install the programme in the navigation system.
• Drive until the initialized sensors start operating normally.
• Set the time and language.
Set the navigation system as explained in the “Operation Manual” or “Hardware Manual”.
After installing the unit, be sure to check at a safe place that the vehicle is performing
normally.
Note:
If you reconnected the Hide-away unit, press the reset button.
Reset button
CRD3914A_inst_001_030_Eng 5/11/04 4:40 PM Page 31