Filter
Top Products
Black plate (57,1)
<CRB2123-A/U>57
Fine-adjusting equalizer curve
You can adjust the center frequency and the Q
factor (curve characteristics) of each currently
selected curve band (EQ-L/EQ-M/EQ-H).
Level (dB)
Center frequency
Q=2N
Q=2W
Frequency (Hz)
1 Press A and hold until frequency and
the Q factor (e.g., F- 80:Q1W) appears in
the display.
2 Press A to select the band for adjust-
ment from among low, mid and high.
Press A repeatedly to switch between the fol-
lowing functions:
LowMidHighB (bass adjustment)T
(treble adjustment)
# If EQ-EX function has been selected and only
when EQ-EX is turned on and CUSTOM is se-
lected as the equalizer curve, you can switch to B
and T.
3 Press m or n to select the desired
frequency.
Press m or n until the desired frequency
appears in the display.
Low: 4080100160 (Hz)
Mid: 2005001k2k (Hz)
High: 3k8k10k12k (Hz)
4 Press r or q to select the desired Q
factor.
Press r or q until the desired Q factor ap-
pears in the display.
2N1N1W2W
Note
If you make adjustments, CUSTOM curve is up-
dated.
Adjusting bass and treble
You can adjust bass and treble settings.
! If EQ-EX function has been selected and
EQ-EX turned on and CUSTOM selected as
the equalizer curve, you can adjust bass
and treble settings.
! If SFEQ has been set to FRT1, bass adjust-
ment affects only the rear output: front out-
put cannot be adjusted.
! If SFEQ has been set to FRT1 or FRT2, tre-
ble adjustment affects only the front out-
put: rear output cannot be adjusted.
Adjusting bass and treble level
You can adjust the bass and treble level.
1 Press A to select B.
Press A until B appears in the display.
# If the treble level has been previously ad-
justed, T will be displayed.
2 Press m or n to select bass or treble.
Press m and B is displayed. Press n and T
is displayed.
3 Press r or q to adjust the level.
Each press of r or q increases or de-
creases the selected bass or treble level. +6
6 is displayed as the level is increased or de-
creased.
Audio Adjustments
En
57
Section
11
Audio Adjustments