Filter
Top Products
Black plate (67,1)
<CRB2123-A/U>67
! No audio is outputted if the center speaker
setting is SML or LRG and no center speaker
is installed.
! Audio is heard only over the center speaker if
installed and the center speaker setting is
SML or LRG.
Selecting a cross-over
frequency
You can select a frequency, under which
sounds are reproduced through the subwoo-
fer. If the installed speakers include one whose
size has been set to SML, you can select a fre-
quency, under which sounds are reproduced
through a LRG speaker or subwoofer.
1 Press A and hold until FRONT appears
in the display, then press A to select HPF.
After FRONT is displayed, press A until HPF
appears in the display.
2 Press m or n to select the speaker
to be adjusted.
Each press of m or n selects the speaker
in the following order:
F (front speakers)C (center speaker)R
(rear speakers)S (subwoofer)
3 Press r or q to select cross-over fre-
quency for the selected speaker.
Each press of r or q selects cross-over fre-
quencies in the following order:
6380100125160200 (Hz)
4 Press BAND to return to the playback
display.
Note
Selecting a cross-over frequency is to set a cross-
over frequency of the subwoofers L.P.F. (low-pass
filter) and that of the SML speaker H.P.F. (high-
pass filter). The cross-over frequency setting has
no effect if the subwoofer is set to OFF and other
speakers are set to LRG or OFF.
Adjusting the speaker
output levels
You can readjust the speaker output levels
using a test tone while listening to music.
1 Press A and hold until FRONT appears
in the display, then press A to select FRT-L.
After FRONT is displayed, press A until FRT-L
appears in the display.
2 Press m or n to select the speaker
to be adjusted.
Each press of m or n selects the speaker
in the following order:
FRT-L (front speaker left)CENT (center
speaker)FRT-R (front speaker right)RER-R
(rear speaker right)RER-L (rear speaker left)
SUB.W (subwoofer)
# You cannot select speakers whose size is set
at OFF.
3 Press r or q to adjust the speaker
output level.
Each press of r or q increases or de-
creases the speaker output level. +10 10 is
displayed as the level is increased or de-
creased.
4 Press BAND to return to the playback
display.
Note
To adjust the speaker output levels in this mode is
the same as making the speaker output levels at
T TONE. Both provide the same results.
Digital Signal Processor
En
67
Section
12
Digital Signal Processor