Filter
Top Products
Installation
En
101
DIN rear-mount
Installation using the screw holes on the side of the unit
1 Remove the frame.
2 Fastening the unit to the factory radio mounting bracket.
English
Español
Deutsch
Français
Italiano
Nederlands
14
Section
Select a position where the screw holes of the
bracket and the screw holes of the head unit
become aligned (are fitted), and tighten the
screws at 2 places on each side. Use either
truss screws (5 × 8 mm) or flush surface
screws (5 × 9 mm), depending on the shape of
the screw holes in the bracket.
Factory radio mounting bracket
Screw
Dashboard or Console
Insert the release pin into the
hole in the bottom of the
frame and pull out to remove
the frame. (When reattaching
the frame, point the side with
a groove downwards and
attach it.)
Frame