Filter
Top Products
Initial Settings
En
71
Adjusting initial settings
Initial settings lets you perform initial set up of
different settings for this unit.
1 FUNCTION display
Shows the function status.
1 Press SOURCE and hold until the unit turns
off.
• Pressing SOURCE on the head unit also per-
forms the same operation.
2 Press F and hold until time appears in the
display.
• Pressing and holding FUNCTION on the head
unit also performs the same operation.
3 Press F to select one of the initial settings.
Press F repeatedly to switch between the follow-
ing settings:
CLOCK—FM—AM—WARN—AUX—DIM—
BRIGHT—SW—(D.ATT)—TEL—DVD
Use the following instructions to operate each
particular setting.
• To cancel initial settings, press BAND/ESC.
• You can also cancel initial settings by holding
down F until the unit turns off.
• Pressing FUNCTION on the head unit also
performs the same operation.
• D.ATT can only be operated when you have
connected the Multi-channel processor (DEQ-
P7050) to this unit. For details, refer to the
Muliti-channel processor (DEQ-P7050) owner’s
manual.
Setting the time
This is used to set the time on the unit’s clock
display.
1 Press
F to select the CLOCK.
Press
F until the time appears in the display.
• Pressing FUNCTION on the head unit also
performs the same operation.
2 Select the portion of the time display you
wish to set with 1 or ¡.
Pressing 1 or ¡ will select a portion of the
clock display:
HOUR—MINUTE
As you select portions of the clock display the
portion selected will blink.
• Pressing 2 or 3 on the head unit also per-
forms the same operation.
3 Select the correct time with E or e.
Pressing E will increase the selected hour or
minute. Pressing e will decrease the selected
hour or minute.
• Pressing 5 or ∞ on the head unit also per-
forms the same operation.
Setting the FM tuning step
The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
1
English
Español
Deutsch
Français
Italiano
Nederlands
10
Section