Filter
Top Products
Initial Settings for
DVD player
Setting remote control code type
When the remote control operation switch is set
to DVD, changing the remote control code type
enables you to operate the Pioneer DVD player
by the supplied remote control. There are three
remote codes, code type A, code type B and
code type DVH.
When using this unit with an Multi-DVD Player
(e.g. XDV-P9), select code A.
When using this unit with a DVD Navigation
Unit, select code B (Not used).
When using this unit only, select code DVH.
1 Set the remote control selection switch on
the left side of the remote control to the
appropriate position with a pen tip or other
pointed instrument .
• If you select DVH mode, there is no need to
take the following procedure.
• If you select A/B mode, take the following
procedure and change the code type to the
appropriate type.
2 Pressing 7 and 0 on the remote control
simultaneously changes the code type.
Initially, the code type is set to A.
Each time you press 7 and 0 simultaneously on
the remote control the code type changes
between A and B.
If you forget your code number
Refer to Changing the Level, step 3 on page 66,
and press CLEAR 10 times.
The registered code number is canceled, letting
you register a new one.
En
70
09
Section