clear network-domain mode 293
clear
network-domain
mode
Removes the Network Domain seed or member configuration from the
WX.
Syntax —
clear network-domain mode {seed | member}
seed — Clears the Network Domain seed configuration from the WX
switch.
member — Clears the Network Domain member configuration from
the WXswitch.
Defaults — None.
Access — Enabled.
History —Introduced in MSS 4.1.
Usage — This command has no effect if the WX is not configured as part
of a Network Domain.
Examples — The following command clears the Network Domain
member configuration from the WX:
WX1200# clear network-domain mode member
success: change accepted.
The following command clears the Network Domain seed configuration
from the WX:
WX1200# clear network-domain mode seed
success: change accepted.
See Also
set network-domain mode member seed-ip on page 298
set network-domain mode seed domain-name on page 300
