Emerson ATCA-S201 Manual

A SERVICE OF

next previous

RTM-ATCA-SXXX Overview

6806800H62B ATCA‐S201InstallationandUseGuide111

ATCAPCB

ATCA Receptacleview

1

5

9

13

2

6

10

14

3

7

11

15

4

8

12

16

17181920

21222324

2526

2829

3031

3334

27

32

Figure 32 Zone 1 J10 Connector Port Pin Location Diagram

Table 46 Connector J10, Zone-1 Pin Assignments

Pin# Signal Pin# Signal Pin# Signal Pin# Signal

1 NC 10 PP_HA5 19 NC 28 VRTN_A

2 NC 11 PP_HA6 20 NC 29 VRTN_B

3 NC 12 PP_HA7 21 NC 30 N48V_A

4 NC 13 PP_IPMB_SCL_A 22 NC 31 N48V_B

5 PP_HA0 14 PP_IPMB_SDA_A 23 NC 32 PPENABLE_A

6 PP_HA1 15 PP_IPMB_SCL_B 24 NC 33 N48V_A

7 PP_HA2 16 PP_IPMB_SDA_B 25 Shelf Ground 34 N48V_B

8 PP_HA3 17 NC 26 Logic Ground

9 PP_HA4 18 NC 27 PPENABLE_B

10.2.3 Zone 2 Connectors

The ATCA-S201 provides Ethernet fabric and base ports on the Zone-2 connector

designated as J23 on the ATCA board. This connector is implemented with a 4-pin

per column type available from Tyco electronics (http://www.tycoelectronics.com),

part number 6469081-1.

Note: The connector pin-outs are presented from the point of view of ATCA blade,

such that:

‘TX’ refers to ATCA as the signal source, and chassis as the signal receiver.

‘RX’ refers to ATCA blade as signal receiver, and chassis as the signal source.