RTM-ATCA-SXXX Overview
6806800H62B ATCA‐S201InstallationandUseGuide36
4.3.1 Auto logout inactivity period
The system will automatically terminate (logout) a remote user after 10 minutes of
in-activity. Optionally, the user can create this file to set an alternate inactivity
threshold value (expressed in seconds):
# echo 60 >/etc/max_inactivity
Note: In absence of this file, the value is set to 600 seconds.
4.3.1.1 Forced user logout
A local user may immediately terminate an active management session by deleting
the following file:
# rm /tmp/curruser
The above command will require the remote user to re-login, or allow the
administrator to launch the atca_blade CLI tool locally.
4.3.2 Single session management override
Blade management is restricted to one admin user at a time, thus preventing blade
configuration conflicts from multiple remote locations. Moreover, a user may not
simultaneously operate the atca_blade CLI tool with the web GUI configuration tool.
Users may optionally override this protection mechanism using either of the
following mechanisms:
Web GUI command
Refer to page 55, Table 24 ATCA status indication, for the instructions to enable this
override “Allow GUI and CLI”.
CLI command syntax
Table 11 CLI command syntax, single session management override
Convention
atca_blade set_useroverride <enable> +
< enable> 0|1
Value 0 disables the GUI, value 1 enables the GUI.
4.4 HTML home page
Once logged in, the user will see the start-up screen shown in the figure below. Left
click the folder panel to expand the menu configuration tools.
Emerson ATCA-S201
+
