6806800H62B ATCA-S201ATCA-S201 Installation and Use Guide 129
13 RTM-ATCA-SXXX
Mechanical and Connector Information
This chapter provides the specifications and connector pin outs for the RTM-ATCA-SXXX.
13.1 Specifications for the RTM-ATCA-SXXX
This section provides mechanical, electrical, environmental, and other relevant
information.
13.1.1 Physical Dimensions
The RTM-ATCA-SXXX is an 8U (233.35 mm) height board with 80 mm in depth for
standard applications. It complies with IEEE 1101.11 mechanical standards, as
required by the PICMG 2.0 Revision 3.0 specification. The RTM-ATCA-SXXX is keyed
to conform to the PICMG 2.10, Keying of ATCA Boards and Backplanes specification.
13.1.2 Power Requirements
There are several manufacturing options for the RTM. Be sure to validate the host
chassis, can supply the RTM slot with these maximum current requirements.
Table 59 Max RTM Module Current Requirements
Module Current ATCA-S201-0
(No Disk)
ATCA-S201-2
(Two disk version)
+12V (spin up < 100
sec)
0.55A(6.6W) 2.05A (25W)
(staggered spin-up)
+12v normal
operating
0.55A (6.6W) 2.05A (24.6W)
+12v (idle) 0.55A (6.6W) 1.55A (18.6W)
OFF STATE LESS THAN
0.4W
LESS THAN 0.4W
13.1.3 Environmental Specifications and Compliance
The environmental specifications for the RTM-ATCA-SXXX assembly are presented
in the table below.
