3 - 114
【#13058(PR)】 SP058 GRA2 Spindle side gear ratio 2
Set the number of teeth on the spindle side when "the gear selection command (control input 4/bit6,
5) " is set to "01".
---Setting range---
1 to 32767
【#13059(PR)】 SP059 GRA3 Spindle side gear ratio 3
Set the number of teeth on the spindle side when "the gear selection command (control input 4/bit6,
5) " is set to "10".
---Setting range---
1 to 32767
【#13060(PR)】 SP060 GRA4 Spindle side gear ratio 4
Set the number of teeth on the spindle side when "the gear selection command (control input 4/bit6,
5) " is set to "11".
---Setting range---
1 to 32767
【#13061(PR)】 SP061 GRB1 Motor side gear ratio 1
Set the number of teeth on the motor side when "the gear selection command (control input 4/bit6, 5)
" is set to "00".
---Setting range---
1 to 32767
【#13062(PR)】 SP062 GRB2 Motor side gear ratio 2
Set the number of teeth on the motor side when "the gear selection command (control input 4/bit6, 5)
" is set to "01".
---Setting range---
1 to 32767
【#13063(PR)】 SP063 GRB3 Motor side gear ratio 3
Set the number of teeth on the motor side when "the gear selection command (control input 4/bit6,
5)" is set to "10".
---Setting range---
1 to 32767
【#13064(PR)】 SP064 GRB4 Motor side gear ratio 4
Set the number of teeth on the motor side when "the gear selection command (control input 4/bit6,
5)" is set to "11".
---Setting range---
1 to 32767
【#13065】 SP065 TLM1 Torque limit 1
Set the torque limit value when "the torque limit (control input 1/bitA, 9, 8) " is set to "001".
---Setting range---
0 to 999 (Short-time rated %)
【#13066】 SP066 TLM2 Torque limit 2
Set the torque limit value when "the torque limit (control input 1/bitA, 9, 8)" is set to "010".
---Setting range---
0 to 999 (Short-time rated %)
