A SERVICE OF

logo

Appendix 2 - 11
MDS-D-SVJ3/SPJ3 Series Instruction Manual
Appendix 2-2 CM10-APxxS-x(D6) angle plug connector
(3) Inserting parts
Insert the clamp nut, the cable clamp, the bushing and the angle back shell to the cable stripped.
(Note) Pay attention to the direction each part is inserted.
Make sure that every part is inserted.
* To insert the angle back shell, bend the cable.
(4) Stripping a core wire
Strip the cable’s core wire to the length 4.5 to 5.0mm.
(Note) Do not mistake the length of the core wire to be stripped.
Do not leave cut or scratch to the cable core.
Cable
Cable clamp
Clamp nut
Bushing
Angle back shell
Cable
Bend
Insert
Angle back shell
4.5 to 5.0
Sheath
Core wire
Cable core