A SERVICE OF

logo

Appendix 2 - 29
MDS-D-SVJ3/SPJ3 Series Instruction Manual
Appendix 2-5 1747464-1 plug connector
(9) To ensure that there is no leaning on the receptacle housing in the receptacle case assembly, drop the
POST BASE for inspection naturally as shown below.
Confirm that the space between the receptacle case assembly and the POST BASE is within 1mm.
Regarding POST BASE for inspection, contact with the sales department of the manufacturer below.
Tyco Electronics K.K. http://www.tycoelectronics.com
(10) Insert the assembled connector until it stick fast to the POST BASE and then, tighten the four bind
screws to fix. The tightening torque of the bind screw is 5.0 to 10.0 N-cm.
POST BASE for inspection
Receptacle case assembly
1mm MAX POST BASE for inspection
Receptacle case assembly