A SERVICE OF

logo

Open as PDF
next previous
Appendix 2 - 23
MDS-D-SVJ3/SPJ3 Series Instruction Manual
Appendix 2-4 CM10-AP-D-CV reinforcing cover for angle plug
(3) The CM10-AP-CV-A (without hexagon nut) set to the receptacle connector and the CM10-AP-CV-B
(with hexagon nut). The cover fit in the flange of the receptacle connector and the CM10-AP-CV-B (with
hexagon nut) with the angle plug connector be set.
(4) Set the hexagon socket head screw (M3x 25), spring washers (for M3) and onto the covers. Using a
hexagonal wrenchor hexagonal screwdriver, tighten the right and left screw equally. Take care to no
gap the cover A and B after tighten the screw. And tighten them additionally with tightening torque of
63cN•m.
[Before setting the Cover]
Slide
[After Assembly]