Filter
Top Products
39-EN
ALPINE DHA-S690 68-09359Z17-A (EN)
1
1
2
To install vertically, attach to the floor using the
hexagonal washer faced tapping screws (M5x15) 1.
• Suspension from the Rear Tray
WARNING
Do not damage pipe or wiring when drilling
holes.
Fasten the L-shaped brackets 2 to both sides of
this unit.
Drill holes about 6mm in diameter and fasten
securely with shouldered hexagonal bolts (M6x50)
7 and shouldered hexagonal nuts (M6) 4.
1
2
1
2
2
2
6
6
4
4
7
7
Checking Operation
Turn the ignition key on and check that the unit is
operating properly, referring to the operating
instructions.
Check that the vehicle’s equipment (horn, stop
lights, etc.) are operating properly.
1
1
1
• Floor base installation
1
Determine the position under the carpet at
which the unit is to be installed.
2
Insert the hexagonal bolts (M6x25) 5 into the
floor base 3, then mount directly on the floor
using the hexagonal washer faced tapping
screws (M5x15) 1.
3
Make X-shaped cuts in the carpet.
4
Install on top of the carpet using the shouldered
hexagonal washer faced nuts (M6) 4.
Horizontal
installation
•When installing horizontally, make sure that the disc magazine’s
slot is on the left side.
Vertical
installation
•When installing vertically, make sure that the disc magazine’s slot
is on the top side.
4
4
4
4
• Installing directly on the floor
WARNING
Do not damage pipe or wiring when drilling
holes.
11
3
55
To install horizontally, attach to the floor using the
hexagonal washer faced tapping screws (M5x15) 1.