Filter
Top Products
11-EN
01GB05VPAB222.fm
ALPINE VPA-B222 68-02065Z86-A (EN)
Rear Entertainment Function
The rear entertainment function independently routes different sources
to the front and the rear inside a car. For example, while listening to the
radio or other audio source in the front, DVD can be enjoyed in the rear
with the optional rear monitor and headphones.
To connect the rear monitor, the optional expansion box VPE-S431 is
required.
1
Press and hold MUTE/RTN/SETUP for at least 2
seconds.
The SETUP screen is displayed.
2
Press the joystick up or down to select REAR
SELECT, then press the joystick right.
The REAR SELECT screen is displayed.
Display Example for REAR SELECT screen
• This function cannot be used when MONITOR-1 or 2 is set to
OFF in SYSTEM SETUP.
3
Press the joystick up or down to select the desired
external monitor.
4
Press the joystick left or right to set the desired
video source (external input).
5
Press MUTE/RTN/SETUP to return to the previous
screen. Press MUTE/RTN/SETUP repeatedly to
return to the main source screen displayed before
starting the setup operation.
• To cancel the rear entertainment function, set to OFF.
• When the “Setting the AUX Mode” (page 15) is set to OFF, the
auxiliary source is not displayed.
• VISUALIZER (VISUAL.) is not displayed when the setting of “Setting
the VISUALIZER Mode Display” (page 16) is turned off.
For remote control operation, the remote sensor of the external device
(monitor, etc.) can be switched, as you prefer.
Switching the Remote Control Sensor
1
In the SETUP screen mode, press the joystick up or
down to select SYSTEM SETUP, then press the
joystick right.
The SYSTEM SETUP screen is displayed.
2
Press the joystick up or down to select REMOTE
SEL.
3
Press the joystick left or right to select the monitor
to be controlled by the remote control.
4
Press MUTE/RTN/SETUP to return to the previous
screen. Press MUTE/RTN/SETUP repeatedly to
return to the main source screen displayed before
starting the setup operation.
• Select SETUP on the FUNCTION screen to recall the SETUP screen
after pressing and holding /MENU/FUNC. for at least 2 seconds.
• The sensor of the touch panel rear monitor has priority over the
sensor of the remote control, if the rear monitor (connected to the
Alpine touch panel rear monitor via the Monitor control lead) is
touched, regardless of the remote control sensor switch setting. Note,
however, that the sensor of the remote control that has been set takes
priority if it has been 5 seconds since last touching the panel.
REAR-1: A rear external monitor can be connected to AUX
OUT 1 of the optional expansion box (VPE-S431).
REAR-2: A rear external monitor can be connected to AUX
OUT 2 of the optional expansion box (VPE-S431)
Switching the function of the remote
sensor
FRONT: Remote control operation can be performed
when the Alpine monitor is connected using an
RGB cable, and also when a monitor (other
than Alpine) connected to a remote control
sensor unit (optional) is connected.
REAR-1: The remote sensor of the external monitor
connected to AUX OUT1 of the tuner box of this
unit, or the optional expansion box (VPE-S431)
is effective, and the remote control can operate
only the source selected for the REAR SELECT
screen.
REAR-2: The remote sensor of the external monitor
connected to AUX OUT2 of the optional
expansion box (VPE-S431) is effective, and the
remote control can operate only the source
selected for the REAR SELECT screen.
01GB00VPAB222.book Page 11 Friday, January 20, 2006 6:37 PM