Filter
Top Products
29-EN
01GB05VPAB222.fm
ALPINE VPA-B222 68-02065Z86-A (EN)
When connected to an Alpine TV unit (sold separately), you can use the
commander supplied with the VPA-B222 to operate the TV. Set the
AUX NAME to TV. Refer to "Naming External Devices" page 15.
• When the optional expansion box (VPE-S431) is connected, connect
TV to AUX IN-2, 3.
• Be sure to connect this unit or VPE-S431 remote control output lead
to the TV unit's remote control input lead.
• For details, refer to the owner's manual of the TV unit.
Operating TV Unit
1
Press SOURCE/POWER.
The source selection screen is displayed.
2
Press the joystick up or down to select TV, then
press / /ENTER.
3
Press and hold for at least 2 seconds to select
BAND.
4
Press / /ENTER to switch the manual tuning
mode.
Manual tune (Auto seek tune) Preset number tune
5
Press or to change the channel up or
down one by one. (manual mode)
The channel is searched and received automatically by
pressing and holding. (Auto seek mode)
Automatic Memory of Channel Presets
1
Press and hold / /ENTER for at least 2 seconds.
The auto preset operation starts.
After the completion, memorized channel number list
displays and the first memorized station is automatically
received.
2
To receive a memorized station, press / /ENTER
to switch the preset number tuning mode.
Manual tune (Auto seek tune) Preset number tune
3
Press or to select a preset number.
Switching Audio
1
Press and hold /MENU/FUNC. for at least 2
seconds.
The FUNCTION screen is displayed.
2
Press the joystick up or down to select AUDIO,
then press / /ENTER.
The audio mode is changed.
TV Operation
(Optional)
WARNING
It is dangerous (and illegal in many states) for the
driver to watch the TV while driving the vehicle. The
driver may be distracted from looking ahead and an
accident could occur.
Install the VPA-B222 correctly so that the driver
cannot watch TV unless the vehicle is stopped and
the emergency brake is applied.
If the VPA-B222 is not installed correctly, the driver
will be able to watch the TV while driving the vehicle
and may be distracted from looking ahead and cause
an accident. The driver or other people could be
severely injured.
Joystick
To activate your TV unit:
To watch a video source, your vehicle must be parked with the
ignition key in the ACC or ON position. To do this, follow the
procedure below.
1 Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2 Keep pushing the foot brake and release the parking
brake once then engage it again.
3 When the parking brake is engaged for the second
time, release the foot brake.
• For automatic transmission vehicles, place the transmission lever
in the Park position.
Now, the locking system for the TV mode operation has been
released. Engaging the parking brake can reactivate the TV
mode, as long as the car's ignition has not been turned off. It is
not necessary to repeat the above procedure (1 through 3), of "To
activate your TV unit."
Each time the ignition is turned OFF, perform the procedure of "To
activate your TV unit."
• If you try to activate the TV unit while driving, the display will
show the warning-PICTURE OFF FOR YOUR SAFETY.
01GB00VPAB222.book Page 29 Friday, January 20, 2006 6:37 PM