Filter
Top Products
36-EN
01GB05VPAB222.fm
ALPINE VPA-B222 68-02065Z86-A (EN)
10
Press MUTE/RTN/SETUP to return to the previous
screen.
• When the speaker is set to the “OFF” mode, the parametric
equalizer for that speaker cannot be set. Refer to “Setting the
Speakers” (page 33).
• It is not possible to adjust the frequencies of adjacent bands within 7
steps.
• Check the playable frequency ranges of the connected speakers
before making the equalizer adjustments. If the speaker’s playable
frequency range is 55 Hz to 30 kHz, for example, adjusting the 40 Hz
or 20 Hz band has no effect. Additionally, you may overload and
damage the speakers.
• When the parametric EQ is adjusted, the adjustment for graphic EQ
becomes ineffective.
Setting Bass Sound Control
1
Check that Defeat mode is off (page 10).
2
Press and hold MUTE/RTN/SETUP for at least 2
seconds.
The SETUP screen is displayed.
3
Press the joystick up or down to select AP SETUP
and press the joystick right.
The AP SETUP screen is displayed.
4
Press the joystick up or down to select B.SOUND
CNTL, then press the joystick right.
You can adjust the sound of low frequencies as desired.
5
Press the joystick up or down to select BASS
COMP.
6
Press the joystick left or right to select the desired
mode.
Bass sound is emphasized more as the mode is
sequentially switched as MODE1 2 3, offering you
vivid low frequencies.
Select OFF when the setting is not necessary.
Press MUTE/RTN/SETUP to return to the previous screen.
Using the previously specified delay number (time difference) allows
you to set a time difference between the front-rear/left-right speakers.
Namely, it enables a time correction based on your preference. With an
initial delay of 0.05 ms for each of the 0 to 400 steps, audible time
correction can be achieved.
5
Press the joystick up or down to select the desired
speaker.
6
Press the joystick left or right to adjust the front,
rear, left and right speakers.
7
Repeat step 5 and 6 to set other speakers.
• Any setting in Bass Focus is applied in time correction, too.
• Press MUTE/RTN/SETUP to return to the previous screen.
Speaker Setup
The PXA-H700 or PXA-H701 can be set according to the playable
frequency range of your speakers.
Check the playable frequency range of the speakers (not including the
subwoofer) before performing this operation to verify whether the
speakers can play low frequencies (of about 80 Hz or less).
• Avoid stopping, pausing, switching the disc, cueing, fast-forwarding
or switching the audio channel of this unit while making this
adjustment. The setting is canceled if Decode mode is switched.
1
Check that Defeat mode is off (page 10).
2
Press and hold MUTE/RTN/SETUP for at least 2
seconds.
The SETUP screen is displayed.
3
Press the joystick up or down to select AP SETUP,
then press the joystick right.
The AP SETUP screen is displayed.
4
Press the joystick up or down to select SPEAKER
SETUP, then press the joystick right.
5
Press the joystick up or down to select the desired
speaker.
6
Press the joystick left or right to select the speaker
characteristic.
7
Repeat step 5 and 6 to set each speaker.
• If the center speaker is turned “OFF,” the center channel’s audio
signals are added to the audio signals output from the front speakers.
• If you set the speaker response to “OFF,” also set the speaker setting
to “OFF” (page 33).
• Perform the setup for all the speakers (“Front,” “Center,” “Rear”
and “Subwoofer”). Otherwise, the sound may not be balanced.
• When the center speaker is set to “OFF”, the setting is ineffective
even if center is set with this function.
• Through changing the settings on each speaker, a change in the
output of the other speakers may occur due to the setting
requirements.
• When using PRO LOGIC II, if the rear speaker is set to “LARGE”,
there will be no output from the subwoofer.
Setting Bass Compressor
Setting Bass Focus
OFF*
1
: When no speaker is connected.
SMALL: When a speaker that cannot play low frequencies
(80 Hz or less) is connected.
LARGE*
2
: When a speaker that can play low frequencies (80
Hz or less) is connected.
*
1
It is not possible to set the front speakers to “OFF”.
*
2
If the front speakers are set to “SMALL”, the rear and
center speakers cannot be set to “LARGE”.
01GB00VPAB222.book Page 36 Friday, January 20, 2006 6:37 PM