Filter
Top Products
6-EN
01GB05VPAB222.fm
ALPINE VPA-B222 68-02065Z86-A (EN)
Operation is carried out by the commander. If an Alpine touch panel
monitor is connected to this unit, the touch buttons appear in the display
to enable touch operation.
This manual explains operation using the commander. For details of the
touch operation, refer to “Soft button operation” on page 39.
• The commander vibrates when an operation is performed. Refer to
“Turning the Commander Vibration ON or OFF” (page 13).
Feature
If an Alpine Ai-NET compatible products (DVD player, DVD/CD
changer), or iPod using the FULLSPEED™ Connection Cable is
connected to the VPA-B222, it can be controlled from the commander
and displayed on the external monitor. If an optional Alpine Navigation
System is connected to the VPA-B222, the Navigation screen will be
displayed on the external monitor, and its operation can be performed.
For details on the function of connected devices, refer to the Owner’s
Manual.
Accessory List
Main unit....................................................................................1
Power cable...............................................................................1
Parking brake sub-lead .............................................................1
Factory System Cable...............................................................1
Pinch connector ........................................................................6
Bracket......................................................................................2
Tapping screw (M4 × 14)...........................................................4
Pan screw (M4 × 8)...................................................................4
Velcro fastener ..........................................................................2
RGB cable (3M) ........................................................................1
RCA extension cable (3M) ........................................................1
Antenna extension cable (3M)...................................................1
Commander ..............................................................................1
Holder........................................................................................1
Commander connection cable (3M)..........................................1
Double-sided adhesive tape......................................................1
Reinforcement screw.................................................................3
Cable clamp ..............................................................................3
Initial System Start-Up
Be sure to press the RESET button when using the unit for the first time,
after installing the CD changer, after changing the car battery, etc.
1
Turn off the unit power.
2
Press RESET with a ball-point pen or similar
pointed object.
Turning Power On or Off
Some of this unit’s functions cannot be performed while the vehicle is in
motion. Be sure to stop your vehicle in a safe location and apply the
parking brake, before attempting these operations.
1
Press SOURCE/POWER to turn on the unit.
• The unit can be turned on by pressing any button.
2
Press and hold SOURCE/POWER for at least 2
seconds to turn off the unit.
By selecting the image source on the unit, it can be displayed on a
connected monitor. For operation, refer to the Owner’s Manual of the
monitor.
If an Alpine monitor is connected (RGB connection)
1 Recall the navigation mode by selecting the image
source on the monitor.
The source of the unit is displayed.
Getting Started
Flipper switch
Joystick
Displaying the Unit Source on the Monitor
RESET
01GB00VPAB222.book Page 6 Friday, January 20, 2006 6:37 PM