Filter
Top Products
16
Switching to radio mode
To start the radio mode,
➮ press the BND•TS button 4
or
➮ press the SRC button ; on the
device or the SOURCE button ;
on the remote control repeatedly
until “TUNER” appears on the dis-
play.
Switching the RDS function on
or off (FM only)
The RDS function expands the per-
formance spectrum of your tuner.
If the RDS function is activated, the
radio automatically tunes into the best
receivable frequency for the station that
is currently set.
To use the RDS function,
➮ press the MENU•OK button 7.
“TUNER MENU” appears on the dis-
play.
➮ Press the MENU•OK button 7 to
display the tuner menu.
“RDS ON” or “RDS OFF” appears on
the display.
➮ To switch RDS on/off, press the
or button 6.
➮ Press the MENU•OK button 7
and then the DIS•ESC button 5
to exit the menu.
The RDS functions are active if RDS
appears on the display.
Selecting the waveband/
memory bank
This device can be used to receive sta-
tions in the FM and AM frequency
bands. Three memory banks (FM1,
FM2 and FMT) are available for the FM
waveband and two memory banks (AM
and AMT) for the AM waveband.
Six stations can be stored in each
memory bank.
To switch between the memory banks
FM1, FM2 and FMT or the memory
banks AM and AMT,
➮ briefly press the BND•TS button 4.
Tuning into a station
There are various ways of tuning into
a station.
Automatic station seek tuning
➮ Press the or button 6.
The radio tunes into the next receiva-
ble station.
Tuning into stations manually
You can also tune into stations manu-
ally.
Note:
You can only tune into stations
manually if the RDS function is
deactivated.
➮ Press the or button 6.
RADIO MODE
01LongBeachDVD35_gb 11.07.2005, 14:38 Uhr16