R-87
QT-6600 Reference Manual
2-15. Magnetic card reading
QT-6600 has the following capability by swiping magnetic card.
1. Customer number entry *1
You can enter customer number, by swiping magnetic card.
<CUST-#> key → Card swipe
• Customer number should be programmed in the customer file.
• Site No. in the mag stripe equals to the programmed value.
• Use Track-1
2. Create dummy check *1
Card swiping activates table transfer.
• Read the customer name from the magnetic card and store it to the check index memory.
• In case of using this feature, program “transfer table by card swiping” (D
10
of the
address 26 of the general control program)
• Use Track-1
3. Clerk sign on *1
Card swiping activates clerk sign on. (effective during signing off only)
• In case of using this feature, the lower 4 digit in the mag stripe should be set to the clerk
number.
• Use Track-2 (If track-2 cannot read, use track-1.)
4. Enter REG 2 mode *1
Cashier/ clerk can enter the REG 2 mode, by swiping card.
<MODE> key → <2> <REG MODE> key → Card swipe
• In case of using this feature, the lower 4 digit in the mag stripe is treated as manager’s
secret number.
• Use Track-2 (If track-2 cannot read, use track-1.)
5. Loyalty card
This function is used to register the key strings such as customer discount etc., by swiping
magnetic card (and scanning OBR code). After swiping a card (track-2)/ scanning a code, the
designated function in the transaction key file is executed.
Procedure
• Using swiping:
<SWIPE> key → Card swipe *1 *2
<SWIPE> key should be allocated in the transaction key file.
If there is no <SWIPE> key on the keyboard, program D
7
and D
6
of the address 24 of the genreral control program to designate the
default <SWIPE> key.
Card swipe *2
• Using scanning:
<SWIPE> key → Code scanning *1*2 Pressing <SWIPE> key is mandatory.
After swiping/ scanning card, the following subjects are performed.
1. Check card expiry (In case of programming check to <SWIPE> key.)
2. Card data check (Checked by D
10
~ D
8
of <SWIPE> key program and unit price field of
<SWIPE> key.
3. Transfer card data (D
7
and D
6
of <SWIPE> key program)
4. Activate function (D
5
~ D
1
of <SWIPE> key program)
*1 In case of setting “Swipe has NOT precedence.” (D
1
of the address 24 of the general control program)
*2 In case of setting “Swipe has precedence.” (D
1
of the address 24 of the general control program)
