Filter
Top Products
MAN 650066:D
21
WATER TEMP SETUP
The water temp setup allows you select the units the temperature is displayed in,
Fahrenheit or Celsius. It also allows you to set a high temperature warning point that will cause
the display to flash whenever the reading on the display is higher than the set point. There is
also a test mode that will display the resistance for the sensor for trouble shooting assistance.
• Press and hold SW 1 while turning the key on.
• Release the switch and then press and release SW1 to get to the “water
waterwater
water” setup menu.
• Press and hold the switch until “-” “water” is displayed to enter the water setup menus, then
release SW1.
• Now you can press and release the switch to scroll through the water sub-menus, “SENDER
S
ENDERSENDER
SENDER”
“WARN
WARNWARN
WARN” “test
testtest
test” “DONE
DONEDONE
DONE”.
• When you get to the desired sub-menu press and hold the switch to select it.
Temp sensor setup (SENDER
SENDERSENDER
SENDER)
This menu is used to set the temp sensor type. Dakota Digital only offers one temp
sensor for this system, it is SEN-04-5, 100-300 F(40-150 C), 1/8” NPT threads. You can use
bushings to adapt the sensor to various locations. You will select “DD F
DD FDD F
DD F” to read in Fahrenheit,
or select “DD C
DD CDD C
DD C” to read in Celsius.
You can also read the temp with the use of a future bus interface module (BIM). Dakota
Digital offers BIM that will allow you to read the engine temp signal from an ECU if you are
installing the system in a vehicle equipped with the OBDII port or a drive train from a newer
vehicle, most 1996 and newer vehicles have this. You will select “BUS F
BUS FBUS F
BUS F” to read in Fahrenheit,
or select “BUS C
BUS CBUS C
BUS C” to read in Celsius.
• When “sender
sendersender
sender” is displayed press and hold SW1 until you get “ - ”
• Release SW1 and the current sensor selection will be displayed
• Press and release SW1 to scroll through the sensor options “DD F
DD FDD F
DD F” “DD C
DD CDD C
DD C” “BUS F
BUS FBUS F
BUS F” “BUS C
BUS CBUS C
BUS C”
• When the desired setting is displayed press and hold SW1 until “ - ” “DONE
DONEDONE
DONE” is displayed
• Release the switch to go onto the next sub- menu item.
Temp warning setup (WARN
W
ARNWARN
WARN)
This menu will allow you to select the high temperature warning point. When the display
value is higher than this point, the WATER display will flash. The value is adjustable from 150 –
300 F (65-148 C).
• When “WARN
WARNWARN
WARN” is displayed press and hold SW1 until you get “ - ”
• Release SW1 and the current warning point will be displayed
• Press and release SW1 to increase the value from “H 150F
H 150FH 150F
H 150F” – “H 300F
H 300FH 300F
H 300F”
• When the desired value is displayed, press and hold SW1 until “ - ” “DONE
DONEDONE
DONE” is displayed
• Release the switch to go onto the next sub-menu item.