Filter
Top Products
3. OPERATION
20
Slide switch “ON”
The external equipment connected to the DVI port (DVI-D1 or DVI-D2) can turn on/off the monitor
unit. See the operator’s manual for the external equipment connected.
Note 1: You can not turn on the power with the /BRILL key on MU-190.
Note 2: When you connect the cables to both DVI-D1 and DVI-D2 ports, turn off the power of both
equipment to turn off the monitor unit.
Slide switch “OFF”
1. Press the /BRILL key to turn on the monitor unit.
2. Press and hold the /BRILL key for three seconds to
turn off the monitor unit. While you hold the key, the
message shown right appears on the screen.
3.2.2 Unlock the key operation
All the keys of the monitor unit are locked by default. Unlock the keys to operate all menus.
1. Turn off the monitor unit.
2. While you hold the PIP key, press the /BRILL key to turn on the monitor unit. Press and hold
the PIP key for more than five seconds. The key operation is unlocked.
Note: When the slide switch is ON, turn on the connected external equipment while you press
the PIP key to turn on the monitor unit.
3. To lock the key operation, turn off the monitor unit and then turn it on while you hold the PIP
key.
The setting of [KEY LOCK] in the [INSTALLATION SETTING] menu ([OFF/ON]) is mutually
changed.
3.3 How to Adjust the Display Brilliance
You can adjust the display brilliance as follows:
Note: This function is available when [AUTO DIMMER] on the [SYSTEM] menu is [OFF] and [EXT
BRILL CTRL] on the [INSTALLATION SETTING] menu is [OFF]. See section 2.1 and
paragraph 3.6.1.
1. Press the /BRILL key momentarily to show the BRILL
adjustment window. The window shown right disap-
pears if there is no operation for five seconds.
2. Press the W or X key to adjust the brilliance (setting range: 1 - 50).
3. Press the S or T key to close the window.
Warning: If you turn off the monitor unit with minimum brilliance, the unit starts with minimum bril-
liance the next time it is turned on. This can make it difficult to see warnings from applications con-
nected, etc. depending on current lighting conditions. If this occurs, do the following according to
the equipment connected;
For FAR-21x7, FEA-2107, FCR-21x7: The brilliance of the monitor unit is adjusted only via the
application of those equipment. See the appropriate operator’s manual.
For Non-SOLAS: Press the /BRILL key repeatedly to adjust the brilliance.
SHUT DOWN
This monitor will shut down in three seconds.
BRILL 46