Filter
Top Products
2020
z
Connection for the Integra/Onkyo Cassette
Tape Deck, CD Recorder or MD Recorder
The z terminal on the DVD Receiver is for connecting
Integra/Onkyo MD recorder, CD recorder or Cassette tape
deck equipped with the same z terminal. When an
Integra/Onkyo component is z -connected, you can point the
remote controller supplied with the DVD Receiver at the
sensor on the DVD Receiver and operate that component
without having to switch remote controllers. In addition, by
connecting components to the z terminal, you can also
perform the system operation given below.
To connect components using the z terminal, simply connect
a z cable from this z terminal to the z terminal of the
other component. An z cable with a 3.5 mm (1/8 inch)
miniature two-conductor plug comes with every cassette tape
deck, compact disc recorder and MD recorder that has an z
terminal.
Power on/ready function
When the DVD Receiver is in the standby state, if an z-connected
component is turned on, then the DVD Receiver also turns on and
the input source selected at this unit automatically switches to that
component.
Direct change function
When the play button is pressed on an z-connected component,
the input source selected at the this unit automatically changes to
that component.
Program Timer
You can operate timer playback and recording using this unit.
Sleep Timer
You can fall asleep to a music/radio program using the timer.
Power off function
When the DVD Receiver is placed in the standby state, all z-
connected components are automatically put in standby mode.
Note
Please change the name displayed by the input selector to match
the connected component (see ‘Changing the “TAPE” display to
match the connected source’ on page 38).
AC
INLET
PREOUT
SUB
WOOFER
TV/LINE
MD/CDR/TAPE
DIGITAL
OPTICAL
AUDIO
REMOTE
CONTROL
AM
FM
75
SURROUND
SPEAKERS
FRONT SPEAKERS
CENTER
R
L
IN
IN IN
OUT
L
R
R
L
OUT
ANTENNA
VIDEO
OUTPUT
S VIDEO VIDEO COMPONENT
YP
B
P
R
IN
IR
L
R
ANALOG
OUTPUT
Integra/Onkyo Cassette tape
deck/CD recorder/MD recorder
Be sure to connect
using the audio
connection cable.
z cable
Notes
• Connect the plugs securely.
• Be sure to connect to the z connectors using the z cable.
• For remote control operation, the audio connection cables must
also be connected.
• If a component has two z terminals, you can use either one to
connect to the DVD Receiver .
• Do not connect the DVD Receiver’s z connector to any
component other than an Integra/Onkyo product. It may cause
malfunction.
• Certain component models may not be able to control this unit.