Filter
Top Products
4
*
3
Not supplied for this unit.
*
4
When using the cable, make sure <iPod (Off)> is selected for <AV Input> (see page 15 of the INSTRUCTIONS).
*
5
To use these components, set the external input setting correctly (see page 16 of the INSTRUCTIONS).
External component
D
Connecting the external components
AV amplifier or decoder
Digital optical cable *
3
Video cord *
3
External monitor
KV-CM1
*
3
Rear view camera
Video cord
*
3
USB cable (approx. 1.2 m)
USB device
Only for KW-AVX726/KW-AVX724
You cannot connect a computer to the USB ( ) terminal of the unit.
Connecting the iPod/iPhone to the USB terminalConnecting the USB devices
You can connect the iPod/iPhone to the USB terminal using the following cables:
• To listen to the music: USB 2.0 cable (supplied with the iPod/iPhone)
• To watch the video: USB Audio and Video cable for iPod/iPhone—KS-U30 (not supplied) *
4
iPod is a trademark of Apple Inc., registered in the U.S. and other countries.
iPhone is a trademark of Apple Inc.
Apple iPod/iPhone
KS-U30
USB 2.0 cable
Apple iPod/iPhone
Connecting the external components to the CD changer jack
When connecting the external components, refer also to the manuals supplied for the components and
adapter.
CAUTION:
Before connecting the external components, make sure that the unit is turned off.
You can connect the following JVC components to the CD changer jack.
JVC component Model name
CD changer (CD-CH) CH-X1500, etc.
You can also connect the following components through the various JVC adapters.
• Connection cords may need to be purchased separately.
Component Adapter Model name
Bluetooth device Bluetooth adapter KS-BTA200
iPod Interface adapter for iPod KS-PD100
Portable audio player with line output jacks Line input adapter KS-U57
Portable audio player with 3.5 mm stereo mini jack AUX input adapter KS-U58
E
To disconnect the connector
Hold the connector top tightly (
1 ), then pull it out ( 2 ).
When connecting two components in series
A KS-BTA200
B*
5
CD-CH / KS-PD100 / KS-U57 / KS-U58
CD changer jack
*
5
When connecting more than one component (maximum: two), it is recommended that you connect the
components in series as explained below.
Signal cord *
3
Install2_KW-AVX726_010A_f.indd 4Install2_KW-AVX726_010A_f.indd 4 12/23/08 12:34:42 PM12/23/08 12:34:42 PM