Filter
Top Products
11
ENGLISH
Searching a station manually:
Manual search
1
Select FM or AM.
1 Press SOURCE
repeatedly to select
FM or AM as the
source.
2 If necessary, press
BAND (B) repeatedly
to select the FM band
number. Each time
you press the button,
the FM band changes
as follows:
Note:
This receiver has three FM bands (FM1, FM2,
FM3). You can use any one of them to listen to
an FM broadcast.
2
Press and hold ¢ or 4 until
“M” (manual) starts flashing on the
display.
3
Tune in to a station you want while “M”
is flashing.
• If you release your finger from the button,
the manual mode will automatically turn off
after 5 seconds.
• If you hold down the button, the frequency
keeps changing (in 50 kHz intervals for FM
and 9 kHz intervals for AM) until you
release the button.
MODE
(FM 1) (FM 2) (FM 3)
F 1 F 2 F 3
BAND
Press ¢ to tune
in to stations of higher
frequencies.
Press 4 to tune
in to stations of lower
frequencies.
ST
When an FM stereo broadcast is hard to
receive:
1 Press MODE (M) to enter the
functions mode while listening
to an FM stereo broadcast.
2 Press MO (monaural) while
still in the functions mode, so
that the MO indicator lights up
on the display.
• Each time you press the
button, the MO (monaural)
and ST (stereo) indicators
light up alternately.
When the MO indicator is lit on the display, the
sound you hear becomes monaural but the
reception will be improved (the ST indicator
goes off).
Lights up when receiving an FM broadcast in stereo.
The MO indicator lights up.
MO
EN10-13KD-SH707[U]f.pm5 23/1/02, 18:4211