Filter
Top Products
9
ENGLISH
2
1
Setting the clock
1
Press and hold SEL (select) for more
than 2 seconds so that one of the PSM
items appears on the display.
(See page 29.)
2
Set the hour.
1 Select “CLOCK H (hour)” if not shown on
the display.
2 Adjust the hour.
3
Set the minute.
1 Select “CLOCK M (minute).”
2 Adjust the minute.
4
Finish the setting.
To check the current clock time while the unit
is turned off, press DISP (D) (display).
The power turns on, the clock time is shown for
5 seconds, then the power turns off.
21
Canceling the display
demonstration
When shipped from the factory, display
demonstration has been activated, and starts
automatically when no operations are done and
no sound comes in for about 3 minutes.
To cancel the display demonstration, follow
the procedure below.
1
Press and hold SEL (select) for more
than 2 seconds so that one of the
PSM items appears on the display.
(See page 29.)
2
Select “DEMO MODE” if not shown
on the display.
3
Select “OFF.”
4
Finish the setting.
To activate the display demonstration again,
repeat the same procedure and select “ON” in
step 3.
Note:
If the unit has been reset (and the power is on),
demonstration will start when no operations is done
and no sound comes in for about 10 seconds.
EN08-09KD-SH707[U]f.pm5 23/1/02, 18:419