Filter
Top Products
13
ENGLISH
2
Tune in to a station (in this example,
of 88.3 MHz).
3
Press and hold the number button (in
this example, 1) for more than 2
seconds.
4
Repeat the above procedure to store
other stations into other preset
numbers.
Notes:
• A previously preset station is erased when a new station
is stored in the same preset number.
• Preset stations are erased when the power supply to
the memory circuit is interrupted (for example, during
battery replacement). If this occurs, preset the stations
again.
Tuning in to a preset station
You can easily tune in to a preset station.
Remember that you must store stations first. If
you have not stored them yet, see “Storing
stations in memory” on page 12.
1
Select the band (FM1 – 3, AM).
1 Press SOURCE
repeatedly to select
FM or AM as the
source.
2 If necessary, press
BAND (B) repeatedly
to select the FM
band. Each time you
press the button, the
FM band changes as
follows:
2
Select the number (1 – 6) for the preset
station you want.
BAND
If the sound quality decreases and the
stereo effect is lost while listening to
an FM station...
In some areas, adjacent stations may interfere
with each other. If such interference occurs,
this unit can automatically reduce the
interference noise (the initial setting when
shipped from the factory). However, in this
case, the sound quality will be degraded and
the stereo effect will also be lost.
If you do not want to degrade the sound quality
and to lose the stereo effect, rather than to
eliminate the interference noise, see “To
change the FM tuner selectivity – IF FILTER”
on page 31.
(FM 1) (FM 2) (FM 3)
F 1 F 2 F 3
Press ¢ to tune
in to stations of higher
frequencies.
Press 4 to tune
in to stations of lower
frequencies.
“1” flashes for a while.
EN10-13KD-SH707[U]f.pm5 23/1/02, 18:4213