Filter
Top Products
108 EuroPak-15a Receiver User Manual Rev 5
Chapter 8 Built-In Status Test
Figure 12: Location of Receiver Status Word
Each bit in the status word indicates the status of a specific condition or function of the receiver. If the status word is
00000000, the receiver is operating normally. The numbering of the bits is shown in Figure 13 below.
Figure 13: Reading the Bits in the Receiver Status Word
The format of the log is described in Chapter 4 of this manual. If the receiver status word indicates a problem, please
also see Section 8.2, Receiver Status Word on Page 107.
8.4.2 Error Word
The error field contains a 32 bit word. Each bit in the word is used to indicate an error condition. Error conditions may
result in damage to the hardware or erroneous data, so the receiver is put into an error state. If any bit in the error word
is set, the receiver will set the error strobe line, idle all channels, turn off the antenna, and disable the RF hardware.
The only way to get out of the error state is to reset the receiver.
The error word is the second last field in the RXSECSTATUS log, as shown in the example below.
Figure 14: Location of Receiver Error Word
The numbering of the bits is shown in Figure 15.
Figure 15: Reading the Bits in the Receiver Error Word
Receiver
Status
Word
<RXSECSTATUSA COM1 0 78.0 FINE 338 320380.000 00a00000 0000 33331
< 1
< L1E5A PM "L1E5AGALT" "DZN05140006"
< “5.000D24" 00CC0000 00000000 00401000
0 0 C C 0 0 0 0
0000 0000 1100 1100 0000 0000 0000 0000
Bit
0
Bit 31
Receiver
Error
Word
<RXSECSTATUSA COM1 0 78.0 FINE 338 320380.000 00a00000 0000 33331
< 1
< L1E5A PM "L1E5AGALT" "DZN05140006"
< “5.000D24" 00A00000 00000000 00401000
0 0 0 0 0 0 0 0
0000 0000 0000 0000 0000 0000 0000 0000
Bit 0
Bit 15