Filter
Top Products
Using Commands and Logs Chapter 4
EuroPak-15a Receiver User Manual Rev 5 33
Table 4: Response Messages
String ID
Meaning
OK 1 Command was received correctly
NOT ENOUGH RESOURCES IN
SYSTEM
3
The request has exceeded a limit (for example, the
maximum number of logs are being generated)
DATA PACKET DOESN’T VERIFY 4 Data packet is not verified
COMMAND FAILED ON RECEIVER 5 Command did not succeed in accomplishing requested task
INVALID MESSAGE ID 6 The input message ID is not valid
INVALID MESSAGE FIELD = X 7 Field x of the input message is not correct
MESSAGE MISSING FIELD 9 A field is missing from the input message
ARRAY SIZE FOR FIELD X EXCEEDS
MAX
10 Field x contains more array elements than allowed
PARAMETER X IS OUT OF RANGE 11 Field x of the input message is outside the acceptable limits
TRIGGER X NOT VALID FOR THIS LOG 14 Input trigger x is not valid for this type of log
NO VALID AUTH CODE FOR THAT
MODEL
19 The model attached to the authcode is not valid
CHANNEL IS INVALID 20 The channel number is not correct
REQUESTED RATE IS INVALID 21 The requested rate is invalid
CHANNELS LOCKED DUE TO ERROR 23 Channels are locked due to error
INJECTED TIME INVALID 24 Injected time is invalid
COM PORT NOT SUPPORTED 25 The COM port is not supported
MESSAGE IS INCORRECT 26 The message is invalid
INVALID PRN 27 The PRN is invalid
MESSAGE TIMED OUT 31 The message has timed out
UNKNOWN COM PORT REQUESTED 33 Unknown COM port requested
HEX STRING NOT FORMATTED
CORRECTLY
34 Hex string not formatted correctly
INVALID BAUD RATE 35 The baud rate is invalid
MESSAGE IS INVALID FOR THIS
MODEL
36 This message is invalid for this model of receiver
COMMAND ONLY VALID IF IN NVM
FAIL MODE
40 Command is only valid if NVM is in fail mode
INVALID OFFSET 41 The offset is invalid
MAX NUMBER OF USER MESSAGES
REACHED
78
The maximum number of user messages allowed has been
reached
GPS PRECISE TIME IS ALREADY
KNOWN
84 GPS precise time is already known