Novatel 15a Car Satellite TV System User Manual


 
EuroPak-15a Receiver User Manual Rev 5 43
Chapter 5 Commands
5.1 Functional Listing of Commands
Table 13 lists the commands by function. Please see Section 5.3 on Page 45 for a more detailed description of
each individual command.
Table 13: Commands By Function
Command Description
COMMUNICATIONS, CONTROL AND STATUS
COM
Set serial port configuration
LOG Request a log
UNLOG Remove a specified log from logging control
UNLOGALL Remove all logs from logging control
GENERAL RECEIVER CONTROL
AGCMODE Control Automatic Gain Control (AGC) functionality
SDLLBW Configure receiver’s DLL filter bandwidth
SPLLBW Configure receiver’s phase-lock-loop bandwidths
RESET Perform a hardware reset
FRESET Reset receiver to factory default
POSITION CONTROL
FIX Constrain receiver position
POSITIONTYPE Control the position solution on GPS L1 or L5 signals
SATELLITE TRACKING AND CHANNEL CONTROL
ASSIGN Assign individual satellite channel
CHANCONFIG Set receiver channel tracking configuration
ECUTOFF Set satellite elevation cut-off angle
PULSEBLANKING
Enable/disable digital pulse blanking for L1 Galileo or E5a signals
STHRESHOLD Control signal thresholds for acquisition, tracking and cross correlation
UNASSIGN Unassign a previously ASSIGNed channel
CLOCK INFORMATION, STATUS, AND TIME
CLOCKADJUST
Enable or disable adjustments to the internal clock and 1PPS output
EXTERNALCLOCK
Set the parameters for an external clock