Filter
Top Products
62 EuroPak-15a Receiver User Manual Rev 5
Chapter 5 Commands
5.3.12 PULSEBLANKING Enable/Disable Pulse Blanking
The PULSEBLANKING command should only be used by advanced users.
This command enables or disables digital pulse blanking. By default, the digital pulse blanking is enabled. The
sensitivity of the digital pulse blanking may be adjusted using the switch field.
Syntax: Message ID: 519
Examples:
PULSEBLANKING L1 5
Table 30: Frequency Switch
Table 31: Pulse Blanking Switch
PULSEBLANKING FREQUENCY SWITCH
Field
Field
Name
Valid Values Description Format
Binary
Bytes
Binary
Offset
1 header
This field contains the Abbreviated ASCII command name. See
Section 4.1 on Page 31.
H0
2 frequency
L1 or L5
Pulse blanking frequency. See
Table 30 below.
Enum
4H
3 switch 0-127 Pulse blanking switch using
thresholds. See Table 31 below.
Ulong 4 H+4
ASCII Description
L1 GPS L1 and Galileo L1 frequency
L5 GPS L5 and Galileo E5a frequency
ASCII Description
0 Disable pulse blanking
1-127 Enable pulse blanking