Filter
Top Products
AG-STAR User Manual Rev 2 52
B.3 FRESET Clear Selected Data from NVM and Reset
The OEMStar freset command is extended to include AG-STAR features. An additional target field, userdata
(value = 10), resets only the AG-STAR user data NVM, thereby resetting all parameters indicated in this
document as “Stored in NVM” to factory defaults. Issuing the freset command with the “target” field set to
standard, resets the userdata NVM as well as OEMStar parameters as indicated in the OEMStar Firmware
Reference Manual.
Table 11: FRESET Target
If you issue the FRESET command without any parameters, it is the same as issuing a
FRESET STANDARD command.
Field
Field
Type
ASCII
Value
Binary
Value
Description
Binary
Format
Binary
Bytes
Binary
Offset
1FRESET
header
- - This field contains the command name
or the message header depending on
whether the command is abbreviated
ASCII, ASCII or binary.
-H0
2targetSee Table 11, FRESET
Target on page 52
Data to be reset by the receiver Enum 4 H
Binary ASCII Description
0 STANDARD Resets commands, ephemeris, and almanac (default).
1 COMMAND Resets the stored commands (saved configuration)
2 GPSALMANAC Resets the stored GPS almanac
3 GPSEPHEM Resets the stored GPS ephemeris
4 GLOEPHEM Resets the stored GLONASS ephemeris
5 MODEL Resets the currently selected model
10 USERDATA Reset AG-STAR only commands
11 CLKCALIBRATION Resets the parameters entered using the CLOCKCALIBRATE command
20 SBASALMANAC Resets the stored SBAS almanac
21 LAST_POSITION Resets the position using the last stored position
31 GLOALMANAC Resets the stored GLONASS almanac