Filter
Top Products
38
Naming a Preset Station
You can name the preset stations so that the name, instead
of the frequency, appears on the display when you select the
station. The following 54 characters can be used:
_ABCDEFGHIJKLMNOPQUSTUVWXYZ” ’&()[ ]*+,-./
=?0123456789
Note
You cannot enter characters for an RDS station that has a program
service (PS) name, since the PS name has priority over other
character information (For more information on RDS stations, see
page 39).
• RDS reception is available only on the European models.
Listening to the Radio
1
FM Auto Preset Memory
This function enables you to store the frequencies into
memory automatically, without having to go through and
store each frequency manually.
Hold down the PRESET MEMORY
button for a few seconds. “AUTO
MEM” will start flashing on the
display. Keep holding down the
button for a few more seconds to
start the Auto Memory function.
The frequencies are scanned from low to high.
Up to 20 FM stations with the best signal
quality are selected, sorted in order from low to
high frequency, and stored into the preset
memory. Even if you have already preset more
than 10 AM stations, you can only store up to
30 AM/FM stations total.
Note
All FM stations previously stored in memory will be replaced with
new Auto Memory stations.
1
2
3
DISPLAY
Theater-Dimensional
PROGRESSIVE SCAN
IPM
PRESET MEMORY
TV/
SETUPTV/
SETUP
TEST TONESP SETUP CH SEL
DISTANCESW MODE UP
TV MUTING
TV
POWER
TV
INPUT
T
-
D SETUPIPM DOWN
TV VOL
+
TV VOL
-
9
TV CH
-
TV CH
+
VOLUME
ON
STANDBY
INPUT SELECTOR
RECEIVER
COND.MLAST M FUNC.M
ANGLEAUDIO SUBTITLE
T
-
D/
STLATE NIGHT
TOP MENU MENU
RETURN
DVD
SETUP
REPEAT
TUNING TUNER PRESET
MD
/
CDR
/
TAPE
A
-
B STEP/
SLOW
TIMER
CLEAR
PROGRAM
SEARCH
ACOUSTIC
CONTROL
SURROUND
RANDOM
--
/
---
MODE
SLEEP
MUTING
DIMMER DISPLAY CLOCK
MODE
+
10 0
SHIFT
9
456
78
123
CURSOR 5/∞
DISPLAY
Hold down
«
Select the station you wish to
name.
See “Selecting preset stations” on page 39.
Press the DISPLAY button on the
remote controller for at least 2
seconds.
The DVD Receiver enters character input
mode, “NAME IN” appears on the display, then
“.....” flashes on the display.
Use the Cursor 5/∞ buttons to
select a character and press the
ENTER button to store the
character.
Flashing “.....” mark appears next to the stored
character.
Repeat step 3 to store more characters. You
can enter characters in any positon by moving
the cursor with the Cursor 2/3 button. You can
store up to 8 characters.
When 8 characters have been entered,
“COMPLETE” appears on the display. To enter
less than 8 characters, press ENTER
repeatedly to move the cursor to the end, or
hold down the DISPLAY button for more than 2
seconds.
Tip
To change an entered name, follow the steps above. In step 3, use
the Left/Right Cursor buttons 2/3 to select the name you want to
change. Change the letters of the name one at a time. To delete a
letter, select the blank space (_). You cannot delete the whole name
at once.
Before operating the
remote controller
Press MODE RECEIVER.