Filter
Top Products
4 To perform seek tuning, keep touching
c or d for about one second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
# You can cancel seek tuning by briefly touching
either c or d.
# If you keep touching c or d you can skip sta-
tions. Seek tuning starts as soon as you release
the key.
# You can also perform seek tuning by pressing
and holding o or p.
Note
Listening AM radio while an iPod is charged from
this unit may generate noise. In this case, turn
the iPod charge setting off and noise is disap-
peared. (Refer to Switching the iPod charge setting
on page 54.)
Storing and recalling broadcast
frequencies
You can easily store up to six broadcast fre-
quencies for later recall.
! Up to 18 FM stations, six for each of the
three FM bands, and six AM stations can
be stored in memory.
1 Touch LIST to display the preset list.
2 When you find a frequency that you
want to store in memory keep touching
one of preset tuning keys P1 to P6 until the
beep sounds.
The selected radio station frequency has been
stored in memory.
The next time you touch the same preset tun-
ing key the radio station frequency is recalled
from memory.
3 Touch ESC to return to the ordinary dis-
play.
Note
You can also use a and b to recall radio station
frequencies assigned to preset tuning keys P1 to
P6.
Introduction of advanced
operations
1 Touch A.MENU and then touch
FUNCTION MENU to display the function
names.
The function names are displayed and oper-
able ones are highlighted.
2 Touch ESC to return to the frequency
display.
# To return to the previous display, touch BACK.
Storing the strongest broadcast
frequencies
BSM (best stations memory) lets you automa-
tically store the six strongest broadcast fre-
quencies under preset tuning keys P1 to P6
and once stored there you can tune in to those
frequencies with the touch of a key.
! Storing broadcast frequencies with BSM
may replace broadcast frequencies you
have saved using P1 to P6.
% Touch BSM on the function menu to
turn BSM on.
BSM begins to flash. While BSM is flashing
the six strongest broadcast frequencies will be
stored under preset tuning keys P1 to P6 in
order of their signal strength. When finished,
BSM stops flashing.
# To cancel the storage process, touch BSM
again.
Operating this unit
En
24
Section
03