Filter
Top Products
Setting the rear output and
subwoofer controller
This unit’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (FULL) or subwoofer (S.W) con-
nection. If you switch the rear output setting
to S.W, you can connect a rear speaker lead
directly to a subwoofer without using an auxili-
ary amp.
! When the multi-channel processor (e.g.,
DEQ-P7650) is connected to this unit, you
cannot operate this function.
1 Touch NEXT on the initial menu.
2 Touch REAR SP.
3 Touch c or d to switch the rear output
setting.
Touch c to select full-range speaker and FULL
appears in the display. Touch d to select sub-
woofer and S.W appears in the display.
# When no subwoofer is connected to the rear
output, select FULL.
# When a subwoofer is connected to the rear
output, set for subwoofer S.W.
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
40).
! If you change this setting, subwoofer output
in the audio menu return to the factory set-
tings.
! Both rear speaker leads outputs and RCA rear
output are switched simultaneously in this
setting.
Switching the sound muting/
attenuation
Sound from this system is muted or attenu-
ated automatically when the signal from the
equipment with mute function is received.
! Sound from this system returns to normal
when the muting or attenuation is can-
celed.
1 Touch NEXT on the initial menu.
2 Touch TEL to select any of the muting,
attenuation or off.
Touch TEL until the desired setting appears in
the display.
! MUTE – Muting
! ATT-20dB – Attenuation (ATT-20dB has a
stronger effect than ATT-10dB)
! ATT-10dB – Attenuation
! OFF – Turn the sound muting/attenuation
off
Notes
! The sound is turned off, MUTE is displayed
and no audio adjustments are possible.
! The sound is attenuated, ATT is displayed and
no audio adjustments, except volume control,
are possible.
! Operation returns to normal when the phone
connection is ended.
Switching the warning tone
If the front panel is not detached from the
head unit within four seconds of turning off
the ignition, a warning tone will sound. You
can turn off the warning tone.
1 Touch NEXT on the initial menu.
Operating this unit
En
48
Section
03